Mega Shed – Part 3: Groundwork, Frame and Piers
7 min read With the site cleared, I can start the Mega Shed build. The base will be constructed first, once groundwork and concrete piers are completed. Continue Reading
7 min read With the site cleared, I can start the Mega Shed build. The base will be constructed first, once groundwork and concrete piers are completed. Continue Reading
8 min read With the design for the Mega Shed setting on I needed to spend time clearing the site before I can start building. And man was that a task. Continue Reading
9 min read Running out of space in the garage is slowing projects to a standstill. A Mega Shed is a good solution but it will need careful designing first.
#bxproject #shed #diy
Continue Reading
4 min read After reports of Freelander 2 tail light theft, I want to take away an opportunity for theft. Installing tail light security screws are a quick and easy fix. Continue Reading
6 min read Being unimpressed with the performance of my existing snow foam system, I wanted to give the Autoglym Polar system a try. Turns out its ace! Continue Reading
7 min read The last-minute BX repairs where to get me to the Late Brake Show on Tour in Manchester. And it did. And the show was fantastic. Continue Reading
5 min read With a little spare time, I thought I would tackle a maintenance job on the Citroën BX. Replacing the HP pump belt was not as simple as I had hoped, but clearly long overdue. Continue Reading
6 min read After releasing the Ender5 article last month, a few people have contacted me about making parts. The first one I’m tackling is the BX boot door trim clip.
#bxproject #Citroen #CitroenBX #carrestoration #Ender5 #3DPrinting Continue Reading
6 min read At last the final scuttle repair can begin. This seems like a simple piece to weld in, but for the next panel to align, it needs to be neat. Continue Reading
7 min read With the suspension turret repaired, I could turn my mind to making repair pieces and welding up the scuttle. Using the highly technical process of CAD. Continue Reading
11 min read While I’ve enjoyed using the Unicubic U1 3D Printer, I’ve found the limitations of its ability. It was time upgrade or buy an Ender 5 Pro. Continue Reading
6 min read After a seized cooling fan motor nearly ended my FotU trip early, I really needed a cooling fan replacement before taking the car out again. Continue Reading
7 min read Last week I went to the Retro Works Car Show in Chester for the first time. After deciding to wash the engine bay, I nearly didn’t make it! Continue Reading
8 min read Non-structural repairs seemed a good place to start the welding, but rot in the suspension turret panel soon changed that! Continue Reading
8 min read A good independent motor factor is a joy, but with so few left I’ve had to turn to AutoDoc for elusive French servicing parts. Continue Reading